Beschrijving | 3 stueck unused electric motors for Saeege machines from Rueetschi
380 / 400 Volt 50Hz Dreick circuit
5.5 KW 11.3 A
2850 rpm
With tool holder (saege leaf holder)
Shaft diameter 30mm
Diameter handle for saege leaf (middle) approx.55mm
Diameter tool holder outside approx.165mm
Total length motor approx. 570mm
Total width approx. 200mm
Price per piece
Hole distance for screwing on the motor
laengs 200mm
Hole spacing Cross 200mm
The abstinfers can be varied in the length and width,
because the motor is screwed on to the console via T-slots.
The T-slots are located on the motor.
Thus, any hole distance would be feasible via a different console.
Thread on the motor shaft is right thread (if the nut is in the
clockwise, is tightened when the motor is counterclockwise
and the mother is hooked- view from the front to the wave)
Diameter of the thread approx. 28-30mm.
direction of rotation could be possible in both directions, as the rear disc is
a groove and the front with two fitting bolts through the saege leaf with the
rear disc can be connected (not necessarily necessary).
Thus, theoretically, even with the direction of rotation, the nut can be
do not loesen.
Special price |
/uploadpic/tramaofinal_inserat/bilder/96708/bild1.jpg
